Dry Coolers, Adiabatic and Hybrid Cooling: Trading Water for Electricity
Heat rejection equipment sits on a spectrum between using more water and using more electricity. Here is how the main types compare.
Key takeaways
- Evaporative cooling uses water to reject heat efficiently. Dry coolers use none but need more fan energy and work best in cooler air.
- Adiabatic and hybrid systems add water only when conditions require it.
- The right choice depends on climate, local water supply, power cost and the cooling loop temperature.
Every data center must send its heat somewhere. For many sites, the final step is a piece of outdoor equipment that moves heat from a water loop into the air. How that equipment works decides how much water and electricity the site uses.
The basic tradeoff
Evaporating water carries away a lot of heat, so evaporative systems can cool well even on warm days with modest fan power. The cost is water consumption. Systems that avoid water rely on air alone, which needs larger surfaces and more fan energy, especially in hot weather. Most designs fall somewhere between.
The main types
- Cooling towers (evaporative). Water is sprayed over fill material while air passes through. Some water evaporates, taking heat with it. Efficient, but consumes water and needs water treatment.
- Dry coolers. A closed loop of fluid passes through finned coils while fans blow air across them. No water is evaporated. Performance depends on the outside air temperature, so output falls on hot days.
- Adiabatic coolers. These are dry coolers with a way to wet the incoming air or the coil surface, such as spray nozzles or wetted pads. Evaporation lowers the air temperature before it reaches the coil. Water use is typically far lower than a tower and occurs only when needed.
- Hybrid coolers. These can run dry, wet or in a combination. In cool weather they operate dry. On hot days they switch to a wet mode. Designs vary.
How climate and loop temperature play in
Dry cooling works best when outdoor air is well below the temperature of the water leaving the building. Modern designs, especially those with liquid cooling, can run warmer water loops. A warmer loop gives dry coolers more margin and can reduce how often water assistance is needed. Cooler loops in hot climates usually push the design toward evaporative help.
The other side of the ledger
Using less water on site is not always a clear win. More fan power means more electricity, and the electricity itself may involve water use at the power plant, depending on how it is generated. Dry systems can also take more space and make more fan noise. Evaporative systems bring chemical treatment, drift and, in cold climates, plume and freeze considerations.
Questions to ask about a design
- What outdoor temperatures was the system sized for, and how often will it need water assistance?
- How much water is expected in a typical year and in the hottest period?
- What is the expected fan power compared with an evaporative option?
- What is the water source, and is reclaimed or non potable water an option?
- How will the system perform during a heat wave, and is there a backup plan?
- What are the noise limits at the property line, and how does the design meet them?
A balanced view
There is no single best answer. A site in a water stressed region may accept higher electricity use to protect local supply. A site with plentiful water and a constrained power connection may choose the opposite. The most useful announcements state both numbers, water and power, and explain why the mix was chosen.
This article is general information for public education. It is not legal, tax, financial or engineering advice. Rules and conditions differ by location, so check with qualified local professionals. Spot an error? Write to info@datacenteroutreach.com and we will correct it.